Monthly Deals
Complete Your Order
Contact Us
8am - 8pm EST Monday - Friday
10am - 7pm EST Saturday

Ecore at Home db-Turf Tiles

This product has been discontinued.
Please see comparable products below.
Quad Blok Connector
Quad Blok Connector
1 Blok per tile (For 2.5" tiles)
Learn More
$3.99 ea.
$3.99 ea.
8" x 48"
Learn More
$83.99 ea.
$83.99 ea.
ADA Ramp Kit
ADA Ramp Kit
(2) ADA Ramps, 6" Trans. Toes, L/R Reducer Pair
Learn More
$314.99 ea.
$314.99 ea.
  • Great for footwork exercises.
  • 5-year warranty.
  • Combine with ECOsmash tiles for a custom workout space.
  • Slip-resistant making it great for pushing and pulling sleds.
  • Indoor use only.
Description - dB-Turf Tile (decibel) features a dense, textured nylon wear layer molded to vulcanized composition rubber. While too abrasive to fall or dive on, this consistent and tight surface is ideal for all footwork drills and can be used with ECOsmash. This 2-foot by 2-foot by 2.5-inch molded tile is designed for areas where extreme durability and ultimate sound and shock absorption are required. dB-Turf Tile mitigates the shock and sound resulting from weights being released onto its surface by absorbing impact.
Material – 3mm dense nylon wear layer fusion-bonded to a 60.5mm vulacanized composition rubber molded base.
Size – 2' x 2'.
Thickness – 2-1/2"
Weight – ~30 Lbs.
Recommended Uses – Ecore at Home's db-Turf Tiles are great for footwork exercises and pushing and pulling sleds and has been used as flooring in commercial gyms, as home gym flooring, in garage gyms, as Crossfit gym flooring, and much more.
db-Turf tiles are very easy to clean and maintain. Maintenance for these interlocking tiles typically includes the following:
  • Periodic sweeping of loose dirt, dust, and debris may be necessary to keep the flooring surface clean.
  • For stains and blemishes, clean the rolls with a warm water solution of household detergent and water. Never use bleach.
  • For animal urine, use a mixture of white distilled vinegar in an equal amount of water. Make sure to flush thoroughly and vacuum any excess solution.
  • For chewing gum, the use of dry ice or refrigerant packets may be necessary to remove gum from flooring surface.
  • If your turf becomes matted, brushing of the surface may be needed to restore the aesthetic appearance. Always use a synthetic brush and never a metal or wire bristled brush when performing this task.

Installation of interlocking tiles is very simple and typically done by the consumer. Typical installation of these tiles is as follows:
  • First, clean your sub floor so it is free of all dirt, grease or debris.
  • Snap a chalk line on the subfloor 24” from one wall in your room. Snap another chalk line on the subfloor 24” from an adjacent wall. You should now have a pair of perpendicular lines making an approximate 90-degree angle.
  • Begin laying the interlocking tiles along the chalk lines, snapping the locks together as you go.
  • Leave the perimeter of the room open until the field is installed.
  • After the field is covered, go back and cut in lines along the walls in the room. Leaving a gap at the wall roughly the thickness of tiles being used is recommended to account for expansion and contraction of the floor tiles in varied temperature ranges.
Note: When piecing interlocking tiles together, adhesives are usually not used since the weight of the locked together product is usually enough to keep the floor tiles from moving. However, if you do experience movement and would like to ensure that the tiles do not slide at all, some double-sided tape or mat tape can be used around the perimeter of the installation to prevent any movement.

For printable installation instructions, please Click Here.
Don't see what you're looking for? 
No results found.
prev page 1 ... ... next page
prev page PREV
prev page PREV
NEXT next page
NEXT next page
Be the first to add a review Write a Review
All Review Images icon View all customer images
Your item was added to the cart
$0.00 total
reg. $0.00