Description - Marquis wall base molding adds a touch of fashion to any space by covering up the expansion gap between your floor and your walls. This wall basing is extremely durable, flexible, Phthalate Free, and is attractive in any setting.
Material – This 100% thermoplastic rubber wall base is Phthalate Free, will not shrink, gap or cup, is FloorScore Certified, and qualifies for LEED Credits.
Length – Sold in sections 8' long with 5 pieces in each carton
Thickness – 3/8"
Height – 6"
Recommended Uses – Can be used to cover the expansion area and floor to wall transitions with most flooring types.
In Stock - Ships between Dec 16 - 18
Installation of moldings is very simple and typically done by the consumer. Typical installation of these moldings is as follows:
- Molding should be installed after floor is in place. Flooring and walls should be properly clean and dry to ensure a secure installation.
- Wall base may be installed on interior plaster, gypsum wallboard, concrete, masonry, mineral-reinforced cement board or similar porous surfaces.
- Cut the wall base to finished length and miter cut the ends for inside and outside corners.
- Secure to wall using an acrylic cove base adhesive. Clean up any excess adhesive prior to drying.