Description - Life Floor Rustic Board tiles are the perfect flooring solution for any outdoor deck, patio, or pool area where large amounts of water may be present. Slip resistant and soft, these floor tiles will give you a functional yet comfortable area where children and adults can run and play with reckless abandon. Easy to install and maintain, these tiles are backed by a 5 year warranty and have the potential to be quite cooler than standard stone or tile floors. With several colors to choose from, we are sure that with this rustic looking floor tile you will once again be able to enjoy any outdoor area all year long.
Note: Foam products can be punctured by sharp animal nails, rough use, high heels, and moving furniture.
Material – Life Floor foam tiles are made with patented EvaTrax technology which is a non-toxic, UV-stable foam-rubber.
Size – 2' x 2'
Thickness – 3/8 Inch nominal (~9.5mm)
Weight – Each mat weighs approximately 1.5 Lbs.
Recommended Uses – Life Floor Rustic Board outdoor foam tiles have been designed to be a premium worry-free solution for barefoot traffic on wet surfaces. These tiles are perfect for outdoor decks, patios, pools, in showers, bathrooms, locker rooms, saunas, underwater in pools, playrooms, games rooms, and many other areas where a safe, non-toxic, slip-resistant floor is desired.
Installation of Life Floor Rustic Board Tiles is very easy and typically done by the customer. Instructions for installation of your new flooring are as follows:
- Measure the installation area to ensure you have enough tiles to cover the desired area.
- Find the center point of the installation area and mark and 'X' at this point
- Without applying any adhesive, lay the tiles out as you would want them to lay in the room without cutting any pieces. Ideally, start from the center of the room where you have marked the 'X'.
- Once you have completed the entire layout without adhesive, begin the adhesion process in the center of the room.
- Using a general paintbrush, evenly apply contact cement on the back of the tile and to the substrate where the tile will fit.
- Let both the back of the tile and the substrate area cure for approximately 5 minutes until the contact cement is tacky.
- Begin by laying down the tile one edge at a time. For all tiles after the first, align the edges tightly to the surrounding tile edges.
- Ensure each corner and edge are secure by applying pressure with the thumb and index finger.
- Using a general roller, apply pressure to the entire tile to secure the tile to the substrate.
- Tiles on the outer perimeter of the room may need to be cut to fit the space. Measure and cut accurately to ensure proper fit.
- If tile is installed in a wet area with drains, cut area over the drain to ensure proper drainage. In addition, you may drill holes in the tiles to allow water to drain through the tile.