Description - The Williamsburg Waterproof Vinyl Plank collection is the perfect low maintenance alternative to hardwood floors that you are sure to love. Backed with foam underlayment underneath, these planks are an all in one solution: providing comfort underfoot while lessening the noise factor. Available in 4 beautiful real wood look colors and backed by a lifetime warranty, you are sure to find your dream floor within the Williamsburg collection.
Material – Williamsburg premium vinyl flooring system is a 100% waterproof wood plastic composite construction with a registered embossing texture for a premium wood feel. Features an attached foam underlayment.
Size – 7" x 48"
Thickness – 7.5mm (.295")
Wear Layer – 20 MIL (.5mm)
Weight – Each carton weighs 30lbs
Recommended Uses – Williamsburg waterproof vinyl flooring has been successfully installed in many versatile locations, such as in basements, bathrooms, bedrooms, offices, entryways, and more.
Engineered vinyl planks are easy to keep clean and maintain. Maintenance of the floor typically includes:
- Daily or weekly vacuuming or dropping of dirt, grit, dust etc.
- Use felt pads under chair and furniture legs to prevent scratching of the flooring surface.
- Place door mats at all entrances to prevent tracked in dirt, rocks, moisture, and other debris.
- Avoid using rubber backed mats as they can stain the flooring surface over time.
- When mopping, use a damp and never a wet mop.
- Clean up spills immediately to prevent damage to the floor.
Installation is simple, and is commonly done by our customers. Installation of TritonCORE planks and tiles is as follows:
- Complete any necessary floor prep.
- Start with the tongue side facing the wall.
- After the initial starter board, press the end seam of the second plank into the end seam of the first plank, and then lock them together by laying the plank down. Continue working left to right.
- Install the first plank in the second row by inserting the tongue into the groove of the plank in the first row. This is best done with a low angle of the plank.
- Insert the long side seam at a slight angle first. As the top surfaces meet, rotate the plank down into the locked position. Engage the end seam, using a rubber mallet if necessary.
- Planks may be cut with a utility knife using the “score and snap” technique, or with the use of a crosscut power saw.
- Continue installing planks removing any gaps using a tapping block and a scrap of flooring to cover the tapping block. Be careful not to damage In*Step tongue and groove.
- Protect all exposed edges by installing wall moulding and/or transition strips. Make sure that no plank will be secured in any way to the subfloor.
For more detailed installation instructions, please Click Here.