Description - Really love all the great qualities of Ecore at Home's ECOsurface rubber rolls but are only doing a small area or want something more manageable? Then look no further than ECOsurface rubber tiles. These straight-cut rubber tiles are the perfect flooring option for any small area or oddly shaped room. Easy to install and maintain, these rubber floor tiles feature the same great features found in the rubber roll, including the factory-applied urethane coating. Great for basements and home gyms, you can say bye, bye, bye to that awful gym smell and hello to so fresh and so clean. A 5-year warranty backs Ecore at Home's ECOsurface rubber tiles.
Material – Vulcanized composition rubber surface with a factory applied urethane coating.
Size – 24” x 24”
Thickness – 3.2 mm thick (approx. 1/8")
Weight – Each rubber tile weighs approximately 3.6 Lbs.
Recommended Uses – Ecore at Home's ECOsurfae rubber tiles are very versatile and have been used as flooring in gyms, as flooring in basements, as flooring in high traffic areas, as daycare flooring, as kitchen flooring, and much more.
Available For Order - Ships between Jun 9 - 16
ECOsurfaces rolled rubber is very easy to clean. Maintenance of these rubber rolls typically includes:
- Vacuuming any loose dust, dirt, or debris from the flooring surface when necessary.
- Occasional damp mopping of the rolls with a pH-neutral cleaner, such as Ecore E-cleaner.
Note: Do not use any solvent or oil style cleaners such as Pinesol, Lysol, Murphy’s Oil Soap, WD40, paint thinner, etc. since these types of cleaners will break down the flooring over time.
For more detailed cleaning instructions and commercial cleaning instructions, Click Here.
Installation of interlocking tiles is very simple and typically done by the consumer. Typical installation of these tiles is as follows:
- First, clean your sub floor so it is free of all dirt, grease or debris.
- Snap a chalk line on the subfloor 24” from one wall in your room. Snap another chalk line on the subfloor 24” from an adjacent wall. You should now have a pair of perpendicular lines making an approximate 90-degree angle.
- Begin laying the interlocking tiles along the chalk lines, snapping the locks together as you go.
- Leave the perimeter of the room open until the field is installed.
- After the field is covered, go back and cut in lines along the walls in the room. Leaving a gap at the wall roughly the thickness of tiles being used is recommended to account for expansion and contraction of the floor tiles in varied temperature ranges.
Note: When piecing interlocking tiles together, adhesives are usually not used since the weight of the locked together product is usually enough to keep the floor tiles from moving. However, if you do experience movement and would like to ensure that the tiles do not slide at all, some double-sided tape or mat tape can be used around the perimeter of the installation to prevent any movement.
For printable installation instructions, please Click Here.