Ecore at Home Ultra-Turf Tile

Details Details

Description - Ultra-Turf Tile features a dense, textured nylon wear layer molded to vulcanized composition rubber. While too abrasive to fall or dive on, this consistent and tight surface is ideal for all footwork drills and can be used with UltraTile. This 24-by-24-by-1-inch modular turf tile offers enhanced shock absorption against impact in moderate to extreme weight drop applications.

Material – 3mm dense nylon wear layer fusion-bonded to a 22.4mm vulacanized composition rubber molded base.

Size – 2' x 2'.

Thickness – 1"

Weight – 16.5 Lbs.

Recommended Uses – Ecore at Home's Ultra-Turf Tile is the perfect flooring option for any home or commercial gym and has been used as flooring in garage gyms, as Crossfit gym flooring, as flooring in sports training facilities, and much more.

Shipping & Returns Shipping and Returns

Out of Stock

Maintenance Maintenance

Ultra-Turf tiles are very easy to clean and maintain. Maintenance for these interlocking tiles typically includes the following:

Periodic sweeping of loose dirt, dust, and debris may be necessary to keep the flooring surface clean.
For stains and blemishes, clean the rolls with a warm water solution of household detergent and water. Never use bleach.
For animal urine, use a mixture of white distilled vinegar in an equal amount of water. Make sure to flush thoroughly and vacuum any excess solution.
For chewing gum, the use of dry ice or refrigerant packets may be necessary to remove gum from flooring surface.
If your turf becomes matted, brushing of the surface may be needed to restore the aesthetic appearance. Always use a synthetic brush and never a metal or wire bristled brush when performing this task.

Installation Info Installation Info

Installation of interlocking tiles is very simple and typically done by the consumer. Typical installation of these tiles is as follows:

First, clean your sub floor so it is free of all dirt, grease or debris.
Snap a chalk line on the subfloor 24” from one wall in your room. Snap another chalk line on the subfloor 24” from an adjacent wall. You should now have a pair of perpendicular lines making an approximate 90-degree angle.
Begin laying the interlocking tiles along the chalk lines, snapping the locks together as you go.
Leave the perimeter of the room open until the field is installed.
After the field is covered, go back and cut in lines along the walls in the room. Leaving a gap at the wall roughly the thickness of tiles being used is recommended to account for expansion and contraction of the floor tiles in varied temperature ranges.

Note: When piecing interlocking tiles together, adhesives are usually not used since the weight of the locked together product is usually enough to keep the floor tiles from moving. However, if you do experience movement and would like to ensure that the tiles do not slide at all, some double-sided tape or mat tape can be used around the perimeter of the installation to prevent any movement.

For printable installation instructions, please Click Here.